Tone Control Circuit Diagram

-

Circuit diagram:

Parts:

P1______________47K  Log. Potentiometer (See Notes)
P2,P3___________47K  Linear Potentiometers

R1,R3,R5_________4K7 1/4W Resistors
R2______________22K  1/4W Resistor
R4_______________1M  1/4W Resistor
R6_______________1K8 1/4W Resistor
R7_____________560R  1/4W Resistor

C1,C4,C5,C7_____10µF  63V Electrolytic Capacitors (See Notes)
C2______________47nF  63V Polyester Capacitor
C3_______________1nF  63V Polyester Capacitor (See Notes)
C6_____________220µF  35V Electrolytic Capacitor

Q1____________BC550   45V 100mA NPN Low noise High gain NPN Transistor

Comments:

A Bass and Treble frequency control to be added to the 3 - 5W Class-A Amplifier was required by some audio enthusiasts. Therefore, this circuit has been designed keeping in mind the extreme simplicity of the amplifier circuit to which it should be linked and was carried out using as few as components possible.
Q1 is the only active component forming a straightforward single-stage transistor amplifier with the tone control network in the ac feedback path. Taking this feedback from the split load of Q1 we obtain an ac stage gain of about 3: this can be useful to cope with low output voltage audio sources.

Technical data:

Input sensitivity:

160mV RMS for 0.5V RMS output

Input impedance @ 1KHz:

Volume control knob to 12 o'clock = 40K

Volume control knob to 2 o'clock = 19K

Maximum output voltage:

4.5V RMS into 10K load

Frequency response:

flat from 15Hz to 23KHz

Total harmonic distortion @ 1V RMS output:

1KHz = 0.008% 10KHz = 0.01%

Total harmonic distortion @ 4V RMS output:

1KHz = 0.06% 10KHz = 0.05%

Bass control frequency range referred to 1KHz:

+11.6dB/-8db @ 100Hz

Treble control frequency range referred to 1KHz:

+7.7dB/-7.3dB @ 10KHz

Note:

• Treble control frequency range can be increased to +8.7dB/-9.9dB by raising the value of C3 to 2n2.
• C1 and P1 are the components with the same labeling already existing in the 3 - 5W Class-A Amplifier.
• C7 is an already existing capacitor labeled C2 in the 3 - 5W Class-A Amplifier. Please note that its polarity must be reversed.
• The circuit is powered by the same 24V supply line of the 3 - 5W Class-A Amplifier. Link 

---