Home » » Simple Power Switching Circuit Diagram

Simple Power Switching Circuit Diagram

Written By MR HARI on Kamis, 08 Agustus 2013 | 05.57

-
This Simple Power Switching Circuit Diagram provides on/off switching, soft starting, current monitoring, current tripping, and protection against over-current for a 30 Vdc power supply at normal load currents up to 2 A. The switch is turned on by an `on` command pulse; it is turned off by an `off` command pulse. An over-current trip can also be set on the bus side by a 6-digit binary signal, which is converted to an analog voltage and compared with the amplified voltage developed across a load-current-sensing resistor. 

Resistor/capacitor combinations (0.027 µ, 2 kfi) at the inputs of the current-sensing amplifiers act as low-pass filters: this introduces a few hundred /is of delay in the response to over-current, thereby providing some immunity to noise. The 0.022 µ capacitors connected to the drain terminals of the PFETs provide a Miller effect, which reduces the rate of change of the drain voltage and therefore the rate of rise of current at turn-on. The soft-turn-on time depends upon the load impedance and is typically 100 to 200 ms.

 Power Switching Circuit Diagram

Simple Power Switching Circuit Diagram

Share this article :

0 komentar:

Posting Komentar


Entri Populer

 
Support : Your Link | Your Link | Your Link
Copyright © 2013. CIRCUIT DIAGRAMS FREE - All Rights Reserved
Template Created by Creating Website Published by Mas Template
Proudly powered by Blogger